humanoid4rent
Sign inGet quotes

New robot dogs of 2025–2026: published specs and what changed

Unitree, DEEP Robotics, ANYbotics and Boston Dynamics have new or updated robot dogs on their spec sheets. Here is what the makers publish, and what it means for events.

By humanoid4rent editorial team · published November 15, 2026

The quadruped market has moved on from the small, light robot dog. Unitree now lists the A2 and As2, DEEP Robotics the LYNX M20 series, ANYbotics began delivering its explosion-protected ANYmal X in October 2026, and Boston Dynamics shipped Spot software 5.2 in September 2026. The common thread is more payload, longer runtime and better weather sealing, which matters for outdoor and long-running events.

This article sets out what each manufacturer publishes on its own pages, as checked on 15 November 2026. All figures are the makers' own claims, not our measurements. Where a maker does not give a launch date, we say so rather than guess.

How to read a robot dog spec sheet

Four numbers matter most to anyone planning an event.

  • Walking payload is what the robot can carry while moving. It is usually far lower than the "standing load", which only describes what it can hold while stationary.
  • Runtime is normally quoted for continuous walking on level ground without a load. A loaded runtime, where given, is the more realistic figure.
  • Ingress protection (IP rating) has two digits: the first for dust, the second for water. Higher numbers mean more protection, but no rating makes a robot suitable for heavy rain on a slippery stage.
  • Maximum speed is a test figure. Robots operating near the public are run far below it.

Unitree A2: a mid-size industrial quadruped

On its A2 product page, Unitree lists a weight of about 42 kg with battery and a continuous walking load of about 25 kg, which it says can reach about 35 kg in ideal conditions. The standing load is given as about 100 kg.

Unitree quotes more than five hours of unloaded continuous walking, around 20 km, with a dual-battery set of 907.2 Wh. With a 25 kg load, the stated figure falls to more than three hours. Speed is listed as 0–3.7 m/s, with a peak of around 5 m/s. The standard A2 is rated IP56; the A2-PRO is given as IP56–IP67, with core components at IP67, and carries two lidar sensors rather than one.

The page does not state a price or a release date. A wheeled A2-W variant is also listed on Unitree's site.

Unitree As2: the compact middle ground

The As2 sits between the consumer-sized Go2 and the heavier A2. According to the Unitree As2 page, it weighs about 20 kg with battery and carries around 15 kg while walking.

Unitree lists a 648 Wh battery and quotes more than four hours unloaded, or more than 2.5 hours carrying 15 kg, with a walking range above 13 km. It describes all models except the As2 AIR as having an IP54 rainproof design. Sensors include an HD camera and lidar, with a higher-grade lidar on the Pro and EDU versions. No arm option is listed, and prices are on request. Again, the page gives no launch date.

For events, the As2's figures suggest a robot that could complete a half-day programme on one battery, but loaded runtimes are what count if it carries branding, a screen or a speaker.

DEEP Robotics LYNX M20: wheels on the legs

DEEP Robotics sells the LYNX M20 as a wheel-legged robot in three versions. On the LYNX M20 product page, the company lists a weight of about 35 kg for the M20 and M20 Pro and about 36 kg for the M20S.

The M20 and M20 Pro are stated to carry 15 kg continuously; the M20S 35 kg. DEEP Robotics quotes about three hours or 15 km unloaded for the M20, and 3.5–5 hours for the M20S. Ingress protection is given as IP66 for the M20 and Pro and IP67 for the M20S, with an operating range down to −20 °C (−30 °C for the M20S).

Two figures stand out. DEEP Robotics gives a maximum tested speed of up to 9 m/s for the M20S, but a maximum operating speed of 2 m/s for all variants. That gap between a test figure and a working figure is common, and the working figure is the one to plan with.

ANYbotics ANYmal X: built for explosive atmospheres

ANYbotics announced on 27 October 2026 that it had started customer deliveries of ANYmal X, an inspection robot for areas where flammable gas may be present. The company describes flameproof casings on the twelve leg actuators and battery, a sealed nitrogen-filled computer compartment and conductive feet to avoid static build-up.

The ANYmal X product page lists ATEX certification for Zones 1 and 2, gas group IIB, T4, and says IECEx certification will follow with first production. It quotes more than three hours per charge with autonomous docking, IP65 for the robot and IP67 for the inspection payload, and an operating range of −10 to 50 °C. ANYbotics marks these as preliminary specifications that may change.

ANYmal X is not an event robot. Its relevance is indirect: it shows how far sealing, certification and autonomous charging have come in industrial quadrupeds, and those features tend to filter down to other models over time.

Boston Dynamics Spot: a software year

Spot's hardware has not changed in its published figures. The Spot product page lists 33.8 kg with battery, a maximum payload of 20.43 kg, an average runtime of 90 minutes, IP54 and an operating range of −20 to 55 °C. Boston Dynamics also states that more than 1,500 Spot robots are with customers.

The changes are in software. Version 5.2.0 of the Spot SDK was published to Boston Dynamics' public repository on 10 September 2026, following 5.1.0 in December 2025. The Spot 5.2.0 release notes list a Stage Planner tool in the choreography previews and project folders for organising routines, alongside new keepalive actions that can cut motor power or halt the robot if a control link is lost.

For show producers, the choreography tools are the relevant part: they make it easier to plan where a dancing Spot will move on a stage before rehearsal. The keepalive behaviour is a reminder that safe stopping on lost connection is something to ask a supplier about, whichever robot is used.

What changed, in short

Comparing these spec sheets with the small robot dogs that dominated events a few years ago, three trends are visible.

  1. More payload. The mid-size models listed above quote walking loads of 15–35 kg, enough for a branded saddle, a small screen or a sensor kit.
  2. Longer stated runtime. Several makers now quote three to five hours unloaded, against 90 minutes for Spot. Loaded figures are lower and should be the planning basis.
  3. Better sealing. IP54 is now the floor rather than the ceiling, with IP66 and IP67 appearing on industrial models.

What has not changed is that these are machines tested and specified for inspection and research. None of the pages reviewed here claims certification for operation in dense crowds, and makers' maximum speeds are not the speeds anyone should use near visitors.

What this means for event organisers

Frequently asked questions

Which robot dog has the longest published runtime?

Among the models reviewed here, Unitree quotes more than five hours of unloaded walking for the A2, and DEEP Robotics quotes 3.5 to 5 hours unloaded for the LYNX M20S. Boston Dynamics quotes an average of 90 minutes for Spot. These are manufacturer figures for continuous walking; carrying a load, stopping and starting, and cold weather all reduce runtime, so loaded figures are the safer planning basis.

Does a high IP rating mean a robot dog can work in the rain at an event?

An IP rating describes protection of the robot's casing against dust and water under test conditions. It does not cover wet, slippery floors, cables, visitor safety or the electronics of add-ons such as screens. Ratings of IP54 to IP67 are listed by the makers reviewed here, but whether a robot works outdoors on the day depends on the supplier's own operating rules and the conditions at the venue.

Why is the maximum speed so much higher than the operating speed?

Manufacturers often publish a maximum tested speed that shows what the hardware can do under controlled conditions. DEEP Robotics, for example, lists up to 9 m/s for the LYNX M20S but a maximum operating speed of 2 m/s. Around people, robots are run far slower than either figure, so it is worth asking a supplier what speed limit it applies in public settings.

Is ANYmal X available for events?

ANYmal X is designed for industrial inspection in industrial areas where an explosive gas atmosphere may occur. ANYbotics announced the start of customer deliveries in October 2026 and sells it with its Shift inspection platform. Nothing in its published material positions it for entertainment or public events, so it is best seen as a sign of where industrial quadruped design is heading.

How this article was made: written by the humanoid4rent editorial team with AI assistance; every factual statement was checked against the sources listed below on 2026-11-15. Spotted an error? Write to info@humanoid4rent.com.

Sources

The facts in this article were checked against these pages on the day it was written.

  1. Unitree A2 | Unitree Robotics
  2. Unitree As2 Compact Size Industrial Capability | Unitree Robotics
  3. Lynx M20 All Terrain Robot Dog – DEEP Robotics
  4. ANYbotics Starts Customer Deliveries of ANYmal X, the World's First Legged Robot Built for Explosive Atmospheres – ANYbotics
  5. ANYmal X – ANYbotics
  6. Spot – Boston Dynamics
  7. Spot Release Notes – Spot 5.2.0 documentation – Boston Dynamics
  8. Commits · boston-dynamics/spot-sdk – GitHub

More from the blog

Want a robot at your next event?

Describe the date, place and what the robot should do once. Suppliers answer with quotes you can compare like for like.

Send a request

Work in robotics? Write for our blog. →